<IMG SRC="nonflash.gif" width=760 height=86 BORDER=0>
 Air Pollution Control System
 Chemical & Corrosion Control System
 Chemical & Process Piping System
 Chlorination Gas System
 Fiberglass Tank & Fabrication
 Plastic & Metal Machining & Fabrication Works


Address and Phone

Flexidynamic Engineering Sdn Bhd
A-3A-28, IOI Boulevard,
Jalan Kenari 5,
Bandar Puchong Jaya,
47170 Puchong,
Selangor, Malaysia

E-Mail: 
fde@flexidynamic.com

Phone: 
603-8079 1878

Fax: 
603-8079 1898
 

Factory
Lot 173, Jalan Tiga,
Kompleks Perabut Olak Lempit,
42700 Banting,
Selangor,
Malaysia

No.6, Hala Perusahaan Kledang Utara 4,
Menglembu Industrial Park,
31450 Menglembu, Ipoh
Perak
Malaysia

Phone/Fax: 
05-281 2114

Composite Fabrication Method

The fabrication of FRP product is governed by various standards that provide guidelines and requirements for composition, performance, construction, design and testing methods of such product.


Fabrication Methods.

Hand Lay-Up is well suited for low volume production of product. This method can be used for both both corrosion barrier and the structural portion.
 
Spray-Up is a faster process and is less labour intensive than hand lay-up. Several drawbacks include possibility of more air entrapment and a difficulty in controlling thickness and resin-to-glass ratios.
 
Filament winding is an excellent process for fabricting round equipment such as tanks, pipes, ducts, etc. Filament winding is recommended only for the structural portion of FRP equipment.
 
Pultrusion is a process that produces parts with a constant cross-section such as I-beams, channels, solid-rods and rails. Pultrusion can produce unfilled parts with glass contents as high as 75% and with very high strengths.
 
Home | About Us | Products | Services | Advantage of "Composite" | Contact Us
Composite Fabrication Method | Ducting, Trunking Design and Conversion Table | Ductulator Ruler
Copyright © 2005 - 2016 Flexidynamic Engineering Sdn. Bhd. All Rights Reserved